Bauder Kontaktkleber contact adhesive is intended for the assembly of BauderTHERMOFOL foil on approved substrates. Assembly bonding of BauderTHERMOFOL U / M membranes in the area of connections with the wall and the attic, on skylights and ventilation. Approved substrates: plastic (GFK), steel, OSB, concrete, glass. Do not use for gluing on the entire surface, on EPS and on non-laminated PUR / PIR thermal insulation.

Mounting / Application

The gluing surfaces must be clean, dry, free of grease and dust-free,
apply the adhesive on both sides with a brush, the cleaned surface can be smeared possibly twice, allow about 10 minutes for ventilation, perform a finger test (no wet places on the surface), apply the adhesive precisely and press firmly, observe safety instructions, close the container after use.

Fire protection and health protection

• Reaction to fire: flammable
• Health hazard: irritant

properties

• Material: nitrile rubber and synthetic resin dissolved in fast evaporating, flammable organic solvents
• Color: light
• Odor: solvent-specific
• Flash point: - 17 C
• Relative thickness: 0.9 0.05 g / cm2
• Viscosity: 3500 mPas
• Consumption: 200 to 300 g / m2 depending on the surface
• Storage: in closed containers for at least 18 months
• Drying time: about 10-30 minutes
• Processing temperature: optimally 15-25 C, minimum 5 C