Sika - SikaMur InjectoCream-100 injection cream
Price on request
discount price
net unit price
£15,39 for item
minimum trading quantity
the amount of product
1.00 item
total price
net list price
£16,87
for 1.00 item
total price
discounted net price
£15,39
for 1.00 item
price-list
gross unit price £20,76
for item
discount price
gross unit price
£18,93
for item
minimum trading quantity
the amount of product
1.00 item
total price
gross list price
£20,76
for 1.00 item
total price
gross discount price
£18,93
for 1.00 item
Product description
A hydrophobic cream used to make a diaphragm in walls that interrupts the rising capillary moisture. It is pressed into a series of holes in the wall joint drilled with a conventional putty gun. No special equipment is required to perform the injection. The product diffuses in a damp wall, creating a diaphragm that prevents capillary water rising.
Features
- easy to use with little risk of error
- one-component material, ready to use
- quick to make - no need to drill holes twice, no pressure or use of gravity
- quick to manufacture, without waiting for material pumping, as is the case with pressure methods or tank refilling, as in gravity methods
- very little material loss
- without the need to pre-seal the surface around the injection holes, which is the case with pressure methods
- approximate, uniform consumption and easy calculation of the amount of material needed
- no special, expensive pumps are required
- almost complete elimination of leakage and dirt on the construction site; no problems related to leakage of injection at partition walls, at recesses
- low hazard, on the water thinner, non-alkaline, non-flammable
- a small amount of waste in
- without the risk of increased occurrence of efflorescence on the surface, which may occur when using silicone material
- formula with a high concentration of active ingredient (about 80%), introducing a smaller amount of passive ingredient into the wall, better results when compared to injections with a large amount of fillers
Application
The product can be used to make a diaphragm that prevents capillary rising of moisture in almost all types of masonry, i.e. brick walls, solid walls, cavity walls (double walls), stone walls and masonry walls with a stone core or similar.
Technical data
- chemical base silane based emulsion w
- white color
- density ~ 0.90 kg / dm 3 (at +20 C)
- ambient temperature at application from +5 C to +35 C; injection works should be performed when the expected wall temperature will not be lower than 0 C for at least 48 hours from the injection, which is to ensure proper diffusion of the material
- storage conditions: store the product in original, undamaged and sealed packaging, in a dry room at a temperature of +5 C to +35 C; protect from direct sunlight and moisture; The material is best used within 12 months from the production date
- 600 ml sausage pack and 300 ml cartridges
The theoretical consumption is shown in the table below. The actual consumption depends on the conditions on the construction site - it is recommended to assume 10% higher consumption than theoretical one.
Technical data